Minolta FLASH METER VI User Manual

E11
Preparations
E10
Preparations
The instrument automatically
checks the battery when power is
on.
After a new battery is installed, the
display appears as shown below
after the power is turned on.
If you turn on the meter when the
battery power is running low,
"b.c." will appear on the display
for approx. 0.5 sec. before the
normal display appears.
★ When disposing of used
batteries, observe local waste
disposal regulations.
● The Flash Meter VI can be
operated continuously for about
30 hours with a fresh alkaline
dry cell.
● The Flash Meter VI has a
power-saving function that
automatically turns off the
power after about 10 minutes of
inactivity.
To restart measuring operation
after the display has been
turned off, press the POWER
button. (Pressing the POWER
button restores the meter to the
condition it was in before the
power was turned off. The
settings for film speed, shutter
speed, measuring mode and
display unit, as well as the
existing measurement data and
memory data, are all retained in
memory.)
3. Checking
If you turn the power on when
there is not enough battery power
to take measurements, or if the
battery runs low during
measurement, a blinking "b.o."
will display for approx. 1 min. and
then the display will switch off. If
this happens, replace the battery
with a new one.
3
Replace the battery
chamber cover.
flashmetervieng.qx3302.12.259:21PMページ10

Minolta FLASH METER VI Specifications

General

Brand	Minolta
Model	FLASH METER VI
Category	Measuring Instruments
Language	English