Minolta FLASH METER VI User Manual

E27
Basic OperationBasic Operation
E26
1. With a sync cord
Measuring flash light
● The meter takes measurements
continuously as you hold down
the spot measuring button. The
digital display in the viewfinder
displays the measurement data.
At the same time, the
measurement data are also
displayed on the dot indicator of
the analog scale R. When the
measuring button is released,
the meter stops taking
measurements. The latest
measurement result appears on
the digital display of the external
data panel and on the dot
indicator of the analog scale R
display.
● Pressing the CLR button clears the measurement data.
* Display example is the same as the case of a still camera. (Refer to page 22.)
4
Press the measuring
button to take readings.
● The meter takes measurements
continuously as you hold down
the incident light measuring
button. The digital display on
the data panel displays the
measurement data. At the same
time, the measurement data are
also displayed on the dot
indicator of the analog scale L.
When the measuring button is
released, the meter stops taking
measurements and displays
only the latest measurement
result.
Insert a battery (p. 9)
↓
Set film speed (p. 12)
1
Prepare the meter to start
taking readings.
2
Press the MODE button to
switch the mode display to
CORD.
● Changing the measuring mode
retains the memory data but
clears previous measurement
data.
● Settings for shutter speed and
display units are automatically
adjusted as follows.
1/1250 to 1/16000 sec.:
adjusted to 1/1000 sec.
EV: adjusted to FNo.
flashmetervieng.qx3302.12.259:21PMページ26

Minolta FLASH METER VI Specifications

General

Brand	Minolta
Model	FLASH METER VI
Category	Measuring Instruments
Language	English