Minolta MNB10Z - Default; Version

5.8 Default
Factory default settings can be restored in this menu. This function will not delete
the media stored on the memory card, and will only reset all of the menu’s setting
back to factory default settings.
1. To access this setting, press the MENU button.
2. Once in the menu, press the RIGHT button twice to switch from Camera settings to
System settings.
3. Press the UP and DOWN buttons to navigate.
4. Select ‘Default’ and press the OK button to enter the submenu.
5. You will be prompted to select from Cancel or OK.
6. Highlight your selection and press the OK button to confirm.
7. Press the MENU button to exit the settings menu and return to shooting.
5.9 Version
This submenu displays the firmware version of the current system. This menu is
informational only and no settings can be accessed or changed here.
1. To access this setting, press the MENU button.
2. Once in the menu, press the RIGHT button twice to switch from Camera settings to
System settings.
3. Press the UP and DOWN buttons to navigate.
4. Select ‘Version’ and press the OK button to enter the submenu.
5. The current firmware version will display.
6. Press the OK button to confirm to exit this screen, and then press the MENU button
to exit the settings menu and return to shooting.