The sound mode has the lock parameter to avoid continuous triggering. If the
lock parameter is off, it is possible that the flash unit will be triggered more
than once and this will ruin the high-speed picture. You can switch the lock
parameter to “ON” to enable single triggering only. You will need to press the
start key again, after the sound mode has triggered once with the lock “ON”.
You don’t need to do that, if you are working as lock is “OFF”.
There might be scenarios where you don’t want to trigger the flash at the first
sound event, but maybe at the second or later ones. In such a case, you can
use the Miops Smart App Scenario mode. Please refer to the Scenario Mode
section of the user manual to get detailed information.
You can also trigger the camera in the sound mode. If you want to do so, just
connect your camera to the Miops Smart with the camera connection cable.
Both of the outputs, the camera and flash connection ports are triggered
synchronously. The DSLR cameras have a certain shutter lag which is quite
high compared to the propagation delay of the sound. The average shutter lag
of a DSLR camera is about 300 milliseconds. You may consider this if you
trigger your camera per a sound event.
To Next Page
Loading...
