6. Camera and Flash Cable Connections
The Miops Smart uses connection cables to trigger your camera or flash unit.
Your unit will be shipped with the proper camera and flash connection cables.
The Miops Smart is a versatile device, which is compatible with many makes
and models. You can use the same device with many different cameras by just
changing the connection cable. If you consider buying a new camera, you can
check the compatibility list to see whether you need to buy a new connection
cable. You can visit the following list to see the compatibility list:
http://miops.com/cablelist/
The Miops Smart has separate outputs for the camera and flash cables. Both of
the output ports are located on the left side of the device under the protective
cover.
The camera cable port is a 2.5 mm stereo female jack. The camera cables
have the male 2.5 mm stereo jack on one end. This end is plugged into the
camera connection port. The other end changes depending on the camera
make and model. This end is plugged in the shutter release port of your
camera.
The flash cable port is a 3.5 mm mono female jack. There is only one type of
the flash connection cable. It has a 3.5 mm male jack on one end. This end is
plugged into the flash connection port. The other end of the cable is a standard
PC Sync port. This end is connected to the PC Sync port of the flash unit. If
your flash does not have a PC Sync port, you can use a hot shoe adapter with
a PC Sync port.
To Next Page
Loading...
