10. Mobile Dongle Mode
The mobile dongle enables you to trigger your camera with a cable connection
from your smartphone. In this mode, you don’t need to have a cable
connection from Miops Smart to your camera. You have to plug the mobile
dongle to the earphone jack of your smartphone. The camera connection cable
will be connected to the mobile dongle and to your camera. Miops Smart will
have a Bluetooth connection to your smartphone. If you are working in the
lightning, sound and laser modes, Miops Smart will detect the events using the
internal sensors and when a triggering event happens, it will command the
smartphone to trigger your camera. In the remaining modes, the smartphone
app does not need the Miops Smart.
The mobile dongle is available in every mode rather than being a standalone
mode. In each mode, on the right top of the screen you will see the mobile
dongle icon. It lets you to switch to the mobile dongle mode of operation.
Before you switch to that mode, you have to plug in the mobile dongle to the
earphone jack of the smartphone. If you touch the mobile dongle icon before
you plug the earphone, a pop-up message will appear. You cannot switch to
mobile dongle mode unless you plug the earphone. You will also need to set
the volume to max level. You will get another warning about that, if the volume
is not set to max.
The mobile dongle requires an active Bluetooth connection between the Miops
Smart and your smartphone for the lightning, sound and laser modes. Please
note that the mobile dongle adds a certain delay to the triggering. This might
affect your setup. If you switch to mobile dongle mode from the cable
connection, you might need to adjust the parameters of that mode.
The mobile dongle is designed to be used with Miops app and a camera only.
Do not use it with other applications or devices. This may cause malfunction
and damage your Miops Smart and device.
To Next Page
Loading...
