you don't need keep the app running. If you want to switch to another
mode or change settings, you will need to start the application again. In
that case, you can use the Search Devices button to discover and connect
to your MIOPS Smart again. A continuous connection is needed when you
are going to use the four release modes: Cable Release, Press & Hold, Press
& lock, Timed Release. These modes will only function properly if there is
an active Bluetooth connection between MIOPS Smart and your
smartphone.
In each mode you will have different parameters. The parameters are
consistent among both the standalone operation and smartphone app. You
can set the parameters per your need. In order to send your configuration,
to MIOPS Smart, you need to touch the start button on the bottom of the
screen. MIOPS Smart will not start to function until you touch the
“start” key.
You can verify if the configuration has been successfully sent, by reading
the notification “Data is sent successfully!” at the bottom of the screen.
When the configuration is successfully sent, you will see that the screen of
MIOPS Smart changes to that mode if it is another mode. If MIOPS Smart
was in the same mode, the screen will refresh with the new adjusted
parameters.
d. Scenario Mode
The scenario mode is most powerful mode of the smartphone app. It is a
revolutionary function, which enables you to combine different sensor and
factors to create a custom scenario to be executed by Miops Smart.
You can define up to three different scenarios and you can save them to use
later. Each scenario can have up to five different steps. Each step can be either
one of six basic modes of Miops Smart (Lightning, Sound, Time Lapse, Laser,
HDR, and DIY) or a certain amount of delay. Each step is fully configurable per
the parameters of that particular mode. The last step of a scenario cannot be a
delay; otherwise there are no restrictions about the order of the steps. The
delay can be up to 59 minutes 59 seconds with one second increments.
You can start adding scenario steps by touching the “plus” sign on the first
To Next Page
Loading...
