use the mobile dongle in the laser mode, please refer to the Mobile Dongle
section of the user manual.
j. HDR (High Dynamic Range)
The HDR mode has also the same parameters with the standalone mode.
They are the threshold, delay and the mode. To get detailed information
about the parameters and the usage of the DIY mode, please refer to the
DIY Mode section in Standalone Mode Operation of Miops Smart (Chapter
8.g).You can set all of the parameters using the DIY mode screen of the
app. To switch from one parameter to the next one, just touch the icon at
the top of the screen. You will see a notch moving to that parameter and
the screen will show the available parameter setting menu. To know how to
use the mobile dongle in the laser mode, please refer to the Mobile Dongle
section of the user manual.
k. Press & Hold
Using Press & hold mode you can keep the shutter open as long as you want.
The shutter will open when you press the circle and it will close whenever you
release it.
l. Press & Lock
Press & Lock mode will open the shutter with a tap on the screen. The shutter
will remain open until you tap the screen again.
m. Timed Release
In this mode you can keep the shutter open for a certain period of time. You
can specify the time period in seconds. You can go up to 1 hour.
To Next Page
Loading...
