The diagram on the right shows an
explanation of the cycles for Miops
Smart and the camera. You need to
make sure that the cycle of the
MIOPS Smart is always equal or
greater than the cycle of the
camera.
You can also set the number of total pictures to be taken in the time lapse
mode. Miops Smart will stop triggering your camera after the number has been
achieved. The total number of the pictures will only be equal to the set frame
number, if the cycle duration of Miops Smart is longer than the cycle of the
camera as explained above. If you get a lower number of pictures in total,
check your camera and Miops Smart settings and change them per the
If you want to start a new round of the time lapse with the same settings, you
can just the start key again and Miops Smart will start taking pictures again.
The scenario mode of the Miops Smart app enables you to combine different
rounds of time lapse with different parameters. Please refer to the Scenario
Mode section of the user manual to get detailed information.
To Next Page
Loading...
