mandatory due to IR light. In such a situation, you can try a laser
source with more output power.
• The second reason of the blinking LM sign can be the shaking of the
laser source and the Miops Smart. A small misalignment can cause
the laser beam to miss the receiver. If you are working outdoors,
wind can be the reason for this. In such a case, you can try adding
some balance weight to your tripod or decreasing the distance
between the laser source and Miops Smart. A laser source which
can stay on all the time with a switch will be easier to work with.
You can look for such a laser from your local suppliers.
After you see the LM sign on the screen, you can press the start key to
get the laser mode running. You can go ahead and make some dry runs
by cutting the beam. The Miops Smart will trigger whenever you cut the
beam with your hand or something else. Again, you can use both of the
You can add some delay to the triggering with the delay parameter. You
can specify any value in milliseconds between 0 and 999. Different from
the sound mode, the distance between the laser source and the Miops
Smart does not make any difference in terms of delay. You just need to
provide a consistent alignment between the laser and the Miops Smart.
The third parameter for the laser mode is the frame number. You can
specify how many pictures to be taken after the laser beam has been cut.
The Miops Smart will trigger your camera so many times equal to the
frame number. You can set the number anywhere between 1 and 999.
Miops Smart can trigger your camera at a maximum rate of 2 times per
second. This means your camera has about 500ms for every picture. Your
camera may need longer than this due to the camera settings. In such a
situation, you will get a lower number of triggering. If your camera is in
burst mode, it is also possible that you get a higher number of pictures
than specified. You will get the exact number of frames, if your camera
needs less than 500ms for every picture and it must be in single shot
The laser mode does not have a LOCK parameter. It will keep triggering if
To Next Page
Loading...
