Turn the temperature control to the full
hot position and continue to run the
shower for at least 1 minute.
This completes the installation of the Mira Advance shower. Please advise the user
how to operate their new shower and leave them with the quick start guide and User
instruction guide.
Post Installation Procedure (Continued)
Turn on the electrical
supply.
Turn the temperature
control to number 8.
Turn on the power to appliance,
check Start/Stop for white light.
Note! The shower will beep 3
times if set to BEAB mode
8 9 10
Start the shower to test for water ow.
The shower will beep once (3 times
when set in BEAB mode) and the white
start stop and orange status light (green
in BEAB Mode) will pulsate. Wait until
the lights go solid and the shower will
beep again
Push Start/Stop to turn off appliance.
Pulsing start/stop light and "beep"
indicates that appliance is shutting down.
Appliance will purge water from heater
tank for a few seconds.
Important! DO NOT isolate power until
water has stopped.
11
12
13 14
To Next Page
Loading...
Need help?
General
