Post Installation Procedure
Turn on the electrical
supply.
Turn the temperature to
full cold.
Start the shower to test for water
ow and run for at least 1 minute. If a
shower drain pump is tted, it should
also start. If there is no water after 5
seconds, make sure that appliance
has been primed.
The shower will beep once when start/stop
button is pressed (3 times for BEAB mode).
The white start/stop button and blue status
light will pulsate and shower will beep again
after few seconds and lights will go solid. This
will conrm ow and cold temperature.
5 secs
Turn on the power to appliance,
check Start/Stop for white light.
Push Start/Stop to turn off
appliance. Pulsing start/stop light
and "beep" indicates that appliance
is shutting down.
Appliance will purge water from heater tank
for a few seconds.
Important! DO NOT isolate power until water
has stopped.
1 2 3
4
x1
6
5
7
BEAB X 3
To Next Page
Loading...
Need help?
General
