3
Menu-Driven Programming
Menu-driven programming allows you to select the feature(s) that you would like to program via the
programming menu. Follow the instructions below to display and navigate through the
programming menu.
Continue pressing until you reach the feature you want to program. See Programming on
page 5 for detailed instructions on how to program features.
Direct Access Programming Codes
Enter one of the Direct Access Programming Codes (see the table below) to immediately access
the particular feature you would like to change. Please note that not all features have Direct Access
Programming Codes.
Step 1: Enter the programming menu
Press to enter the programming menu.
Step 2: Scroll to first menu option
Press to scroll to the first menu option.
• To exit to normal mode press .
• To exit from the programming menu, press .
Step 3: Scroll to second menu option
Press again to scroll to the second menu option.
The display will now show the first programmable
feature.
Code Function Factory Default How to Program
*000 Exit programming mode *000 N/A
*101 Add a new record N/A See page 5.
*202 Delete a record N/A See page 8.
*222 Enter a prefix (0) 0905 See page 6.
*303 Enter keyless entry codes N/A See page 9.
*404 Delete keyless entry codes N/A See page 9.
*505 Change master code *999 See page 10.
*606 Select pulse (rotary) or tone (DTMF) Tone 11 See page 12.
*707 Set door open timer 10 seconds See page 12.
*808 Set on-line timer 60 Seconds See page 12.
*909 Select multiple/single entrance Multi 00 See page 13 .
1=Up 3=Down
#=Execute
8 8 8
To Exit PROGRAM
MODE - Press #
3
Enter Resident
Codes - Press #
3
3
To Next Page
Loading...
Need help?
General
