Mircom TX3 Series - Page 12

12 TX3 Telephone Access System Programming Manual Version 2.7
LT-979 Copyright 2018
Configuration
To access the operation menu
1. Press 9 9 9 9. The configuration information appears.
2. Press the (scroll down) to “Operation”.
3. Press the telephone key.
4. Enter your passcode, then press the telephone key.
or
If you have not set a personal passcode, press 3 3 3 3, then press the
telephone key. This number is the four-digit factory default.
5. The “Operation” menu appears.
To view logs
1. Press the arrow key to scroll to “View Logs” and press the enter
(telephone) key. The system information appears.
If you have just installed the system, following message appears.
Main Menu
1 Configuration
2 Operation
3 View Cfg Info
4 View time & dat
Operation Menu
1 View logs
2 Delete logs
Logging data not
present