Mircom TX3 Series - 1.5 ADA Mounting Requirements and Warranty

Configuration
Version 2.7 TX3 Telephone Access System Programming Manual 17
LT-979 Copyright 2018
2.7.1 Tone/Pulse mode
Note: Although this option appears on the front panel, it is not
configurable. The telephone always operates in tone mode. Pulse
dialing is not available.
To access the Tone/Pulse option screen
1. Press the arrow key to scroll to “Tone/Pulse mode” and press the telephone
key. The tone/pulse selection appears.
2. Press the info key to return to the previous menu.
2.7.2 Line Type
The Line Type function defines each of the 5 telephone lines as ADC, NSL or not
used. By default is line 1 is ADC and lines 2 to 5 as unused.
To define the line type operation
1. Press the arrow key to scroll to “Line Type” and press the telephone key.
The line selection appears.
2. Using the down arrow key to select L-1, and press the telephone (enter)
key. The line type selection appears.
3. Use the ‘*” and or “#” key to make a selection.
4. Press the telephone key to enter the selection.
5. Press the info key to return to the previous menu.
Line Type
L-1
L-2
L-3
Select Line Type
[ x ] ADC Type
[ ] NSL Type
[ ] Unused