Mircom TX3 Series - Page 24

24 TX3 Telephone Access System Programming Manual Version 2.7
LT-979 Copyright 2018
Configuration
To set the Keycode Schedule
1. Press the arrow key to scroll to “Keycode Sch” and press the telephone
(enter) key. The Keycode Schedule selection appears.
2. Press the up and down arrow keys to scroll through the schedules as shown
above. The default is “Always”.
3. Use the up and down arrow keys to select the schedule and press the
telephone (enter) key to accept.
4. Press info key to return to previous menu.
2.7.14 Call Wait Key
The Call Wait Key function defines the key the resident presses to place an
outside call on hold. The default key is 2.
Note: This feature applies to NSL lines only.
To set the Call Wait key
1. Press the arrow key to select the “Call Wait Key” and press the telephone
(enter) key. The Call Wait Key selection appears.
2. Press the up and down arrow keys to scroll through the available keys.
Valid keys are 1 to 9, * or #.
Unlock Sch
0 Always
1 Never
2 Weekdays
3 Weekend
4 Evenings
5 Holidays
Call Wait Key
[ ] 1
[ ] 2
[ ] 3