Mircom TX3 Series - Page 50

50 TX3 Telephone Access System Programming Manual Version 2.7
LT-979 Copyright 2018
Configuration
Level 1. Not used.
Level 2. Level 2 passcode allows access to the operation menu.
Level 3. Level 3 passcode allows access to both operation and configuration
menu. The level 3 passcode is also a network passcode used by the configurator
software. If the level 3 passcode changes, the configurator will not be able to
connect to the panel unless the network password is set to the level 3 passcode.
To change a passcode
1. Press the arrow to scroll to “Change Passcode” in the main configuration
menu and press the enter (telephone) key. The “Enter Access Level” entry
appears.
2. Press the arrow keys to scroll to your access level and press the telephone
(enter) key to accept.
3. Enter the new passcode. It can be up to 10 digits long.
Note: If you forgot the new passcode, call Mircom’s Technical Support
Department. See Technical Support contact information in
Section 1.5).
4. Press the telephone (enter) key to accept. The “Enter New Passcode” entry
appears.
5. Press the enter (telephone) key to enter the new passcode. The “Re-enter
New Passcode” entry appears.
6. Re-enter the new passcode.
7. Press the enter (telephone) key to finalize entry of the new passcode.
8. Press info key to return to previous menu.
Enter Access Level
< 001>
Enter new Passcode
----------
Re-enter new Passcode
----------