miRider One - Replacing the Innertube; Lubricating the Chain

63
8.4. REPLACING THE INNERTUBE
Youre-bikewheelshaveinnertubeslledwithsealanttopreventpunctures.Iftheholein
the innertube is too big, the sealant will leak out along with the air.
When a hole occurs in the innertube, you will need to replace the innertube. It’s advisable
to carry a spare innertube, pump, and puncture kit with you whilst cycling. Visit our
YouTube channel for more information on how to change your innertube. See chapter .
NOTICE
Do not let the rear wheel dangle from the power cable when maintaining the wheel using
a cycle maintenance stand. Letting the rear wheel dangle by the power cable may cause
irreparable damage. Always disconnect the power cable and wheel completely from the
bike before commencing maintenance.
8.5. LUBRICATING THE CHAIN*
*This chapter is only applicable for the MiRiDER One.
6
WARNING
Do not lubricate the drive belt. Lubricating the drive belt may cause the drive belt to slip
and void warranty.
1. Degrease and clean the chain.
2. Relubricate the chain once per week to keep optimised performance and to prolong
the life of your e-bike.