Instruction Manual MIT-SCAN-T3 Version 02/2021
accuracy of measurements. The wheels should have the wheel
diameter specified in the test report.
In addition, regular maintenance is recommended.
MIT-SCAN-T3 is ready for use as soon as it is switched on. The user
should check the prober function of the electronic by performing some
test:
- In search mode (s. sec. 3.3.1), there must be four bars
indicating a change when transitioned over a metallic object.
- Perform a function test with the MIT wheeled spacer (accessory
part) as described in sec. 3.4.
To Next Page
Loading...
