MIT MIT-SCAN-T3

Instruction Manual MIT-SCAN-T3 Version 02/2021
Page 22
2.6.3 Menu “Settings”
Under this menu item, device specific settings can be made
(s. adjacent Fig. 20):
 “Language” German| English
 “Unit” mm | cm | in, mi | in, ft
 “Bluetooth” (if available) On | Off
 “GPS” On | On, no warnings| Off
 “Vibration” On | Off
“Date, Time” manual input of date and time
3 Performing a measurement
3.1 Before the measurement
It is recommended to check the mechanical condition and function of
the device before the first measurement of the day. The device should
be visually inspected for external damages. If damage has been
discovered and it is uncertain if this affects the measurement, it is
recommended to contact the manufacturer.
The wheel diameters are specified in the calibration certificates. The
wheel diameter can wear because of abrasion and may affect the
Fig. 20 Menu - Settings
Please note:
If GPS is enabled, measuring
site specific GPS data will be
stored. A warning is displayed
if there is no GPS signal. This
warning can be turned off in
the settings menu.