Instruction Manual MIT-SCAN-T3 Version 02/2021
5.5 Selection of measured values
Data transferred from device can be selected in tab “Data”.
It is possible to filter the measurement data using the filter function
(s. Fig. 44). Several criteria can be queried at the same time.
Data sets can also be selected in the table:
To select all data sets:
Left-click with the mouse in the table, then use key combination
“Ctrl + a”
To select related data sets:
Click on first data set, then hold shift key pressed and click on
last marked data set
Fig. 44 Selection of measured data set by filter
To Next Page
Loading...