Instruction Manual MIT-SCAN-T3 Version 02/2021
5.3 Selection of devices
The MIT Project Software can be used to read-out the measured data
from USB flash drive. If a USB flash drive with data files (*.T3) is
connected while the program is running, the program shows a
message.
The MIT-SCAN-T3 data can be linked to each respective device by
assignment of a name or number. This is helpful when several devices
are in use and another designation than the internal device number is
preferred. It is possible to activate and load several files. The
respective file is selected in the menu “device” (s. Fig. 39).
Fig. 38 File query for MIT-SCAN-T3 data
Fig. 39 Program screen shot
device selection
To Next Page
Loading...