MIT MIT-SCAN-T3 - Set up of Measuring Sites at the PC

Instruction Manual MIT-SCAN-T3 Version 02/2021
Page 45
5.2 Program settings
In menu item “Extras”, different settings can be made (s. Fig. 37):
 “Language”
German or English
 “Units”
international (mm/cm for depth, m for step size) or Anglo-
American (inch for depth, foot/mile for step size) and the unit
for result display (form sheet).
 “Multiple measurements”
It is possible to average the results from several measurements
at the same measuring site or alternatively use the last result in
the form sheet.
 “Plausibility of measurements”
The program checks whether the measured value is within the
measurement range of a respective reflector.
 “Form sheet preview”
 With the selection of a data set, a simultaneous calculation of
values is performed in the form sheet.
Fig. 37 Program settings