4
8575
8575
N/B Maintenance
N/B Maintenance
1. Hardware Engineering Specification
1.1 Introduction
The 8575 motherboard would support the Intel® Pentium® 4 processor with FCPGA packaged, mPGA478
Socket, which will supports the different levels up to Willamette P4 1.7GHz (Throttling)/Northwood above
2.0GHz (Throttling).
The memory subsystem supports 0MB on board memory, two JEDEC-standard 200-pin, small-outline, dual
in-line memory module (SODIMM), support PC2100 & PC2700.
This system is based on PCI architecture, which have standard hardware peripheral interface. The power
management complies with Advanced Configuration and Power Interface (ACPI) 1.0. It also provides easy
configuration through CMOS setup, which is built in system BIOS software and can be pop-up by pressing
F2 at system start up or warm reset. System also provides icon LEDs to display system status, such as power
indicator, HDD/CDROM, NUM LOCK, CAP LOCK, SCROLL LOCK, SUSPEND MODE and Battery
charging status. It also equipped 2 USB ports.
SiS650 IGUI Host Memory Controller integrates a high performance host interface for Intel Pentium 4
processor, a high performance 2D/3D Graphic Engine, a high performance memory controller, an AGP 4X
interface, and SiS MuTIOL® Technology connecting w/ SiS961 MuTIOL® Media I/O.
To Next Page
Loading...
