Mitel 5055 - Enabling Multiple User Profiles

5055 SIP Phone User Guide (Rev. A)
- 84 -
rdvmail2= 0
#ring tone entry 2 block the call(0 diabled, 1 enabled)
rdblock2= 0
#ring tone entry 3 key word
rdkw3=
#ring tone entry 3 type(0-16)
rdringtype3= 0
#ring tone entry 3 forward to voice mail(0 disalbed, 1 enabled)
rdvmail3= 0
#ring tone entry 3 block the call(0 diabled, 1 enabled)
rdblock3= 0
Note: You can define the same parameters defined in SIPGeneric.cfg here. When defined
here, the parameters overwrite the values in the SIPGeneric.cfg file.
Enabling Multiple User Profiles
Use this procedure to enable Multi-User Profiles:
1. Navigate to "Configure Upload/Download Page"
2. Click on "Download" to save configuration parameters to download.txt file
3. Modify download.txt file entry from:
multi_user_enable= 0
to
multi_user_enable= 1
4. From "Configure Upload/Download Page" browse to download.txt file and click on "Upload"