About This Document
This document provides the information that you need to configure the various settings on the
UC360, for example, the network settings, the SIP settings, the camera settings, and so forth.
It also describes procedures to back up and import settings, and upgrade the software.
For more detailed information, see the following chapters:
• how to launch Settings and configure Advanced settings for the UC360- see “UC360
Configuration” on page 5
• how to configure MCD settings for the UC360 - see “Programming MCD for the UC360” on
page 63
• how to configure settings for the 5000 CP - see “5000 CP Configuration for the UC360” on
page 75
Related Documentation
See the following documents for more information on the UC360 Collaboration Point.
• UC360 User Guide — describes how to use the UC360 to make and receive calls, launch
the various applications, and display and share presentations.
• UC360 Installation Guide — provides instructions on how to physically connect the UC360.
• Revolabs HD™ Dual Channel System Microphone Installation Guide — provides in-
structions on how to install the Revolabs HD Single/Dual Channel Wireless Microphone
system. It also provides guidelines on charging, placing, and using the extension micro-
phones on the UC360.
• UC360 Universal Camera Mount Installation Guide — provides instructions on how to
mount the UC360 universal camera mounting bracket and camera to the display monitor.
• UC360 Quick Reference — provides basic procedures on how to make
conference calls, handle calls, and do in-room and remote presentations.
• UC360 Engineering Guidelines — provides information on the UC360
engineering requirements.
• MCD System Administration Tool Online Help — Refer to this online help system for
instructions on how to program SIP devices on the MCD system.
To access UC360 and system-specific documentation:
1. In your browser, go to http://www.edocs.mitel.com.
2. Select a documentation suite from the following drop-down menus:
- Applications -> Conferencing and Collaboration -> UC360 Collaboration Point
- End User Documents
3. Log in if asked to do so.
4. To view a document, click on the document title.
To Next Page
