UC360 Administration Guide
UC360 Programming
Follow the steps below to program the UC360 with the 5000 CP Server Address, User Name
and Login Name.
1. Press to display the Menu bar.
2. Press Settings .
3. Press Advanced.
4. Enter the password. (Tapping in this area will bring up on-screen keyboard, if a physical
keyboard is not attached.)
The default password is "admin".
5. Press OK.
6. Press System Settings.
7. Tap SIP Settings.
8. Enter the Server Address
. This is the IP address of the 5000 base processor.
Note: If using PS1, then enter the 5000 PS1 IP address instead of the base processor.
9. Enter the Username. This is the Extension number on 5000.
10. Enter the Login Name. This is the Extension number on 5000.
11. Enter the Login Password. This is the Extension number of the 5000 by default, unless
it was changed.
12. Tap the Back key to Exit.
At this point, the UC360 will be functional for placing and receiving calls. After exiting the UC360
programming, it will take a few minutes for the network connection to cycle and establish the
SIP registration. If for some reason it fails to register, confirm the password for the SIP extension
on the 5000 CP and make sure it matches on the UC360. A power cycle of the UC360 maybe
required after confirming the credentials
.
To Next Page
