UC360 Administration Guide
Setting Up and Configuring UC360 Cameras
Follow the instructions in the camera’s Installation Guide to set up the camera. You will need
the camera’s IP address, username and password in order to configure Camera settings in the
UC360.
Use the software CD supplied with the camera or download the software from the camera’s
website. See the appropriate section below for your camera type.
Ethernet Camera Firmware
It is important to ensure that the ethernet cameras are running the correct versions of firmware.
• The Panasonic cameras must run the minimum version of firmware shown in the Table
below.
• The AXIS cameras MUST run a specific version of firmware; see the Table below for the
Required Firmware Revision.
• The Sony cameras must run the minimum version of firmware shown in the Table below;
however, the Sony cameras can be run with newer versions of firmware.
Table 1: Cameras and Minimum Firmware
Ethernet Camera
Required
Firmware
Revision,
Release 2.1
Required
Firmware
Revision,
Release 2.0,
SP1
Required
Firmware
Revision,
Release 2.0
AXIS M1054 5.50.3 5.40.9.3
(See Note)
Use latest version
(See Note)
AXIS: M1104 5.50.3 5.40.9.3
(See Note)
Use latest version
(See Note)
Sony CH-110 1.82 v1.78 Latest version -
minimum 1.73
Sony CH-120 1.82 v1.78 Latest version
minimum 1.73
Panasonic
WV-SP105
1.82 1.66 Latest version -
minimum 1.46
Panasonic
WV-SP305
1.83 1.66 Not applicable
Note: ONVIF user required. See “Create an ONVIF User in Axis” on
page 35.
To Next Page
Loading...
