Mitsubishi Electric E70 Series User Manual

E70 Series Instruction Manual
Appendix 7.19 Other Operation Messages
IV - 165
Appendix 7.19 Other Operation Messages
Message Details
Executing automatic operation
- Cannot be performed during automatic operation.
Perform the operation again after automatic operation has been completed.
Setting error
- The setting data is inadequate. (Alphabetic characters were set where only
numeric characters can be set, etc.)
- The data has not been set.
- There is no specification.
Data range error
- The input data exceeded the range.
Set the value again within the range.
Data protect
- Setting, erasing, parameter setting, etc., of the various data is prohibited,
because the data protect key is validated.
Reconsider the data protect key setting.
Write protect
- Attempted to create a new program file in the write-protected device
- Opened the program file of the write-protected device
- Attempted to save the program file of the write-protected device
- Attempted to correct the buffer for the write-protected file.
- Attempted to edit or correct the buffer for the read-only program file.
Edit lock B
- It is not possible to change machining program B (8000 to 8999: user standard
subprogram) or machining program C (9000 to 9999: machine tool builder
custom program) as edit lock B is enabled.
Edit lock C
- It is not possible to change machining program C (9000 to 9999: machine tool
builder custom program) as edit lock C is enabled.
Origin set not possible
- The operation is in a state in which origin set is not possible.
Check the parameter "#1123 origin (Origin set prohibited)" setting.
- Check that the axis has stopped.
- Check that idling (post-reset status) is currently being performed.
Can't command manual value
- The manual numerical value protect is valid and therefore it is not possible to
perform a manual numerical value command.
Getting T code list - T code list is being retrieved.
T code list complete - Retrieving T code list is completed.
Load meter display not possible
- The load meter cannot be displayed.
Contact the machine tool builder.
Pallet running - Each setting was executed during pallet running.
APC executing - Each setting was executed during automatic pallet changer executing.

Mitsubishi Electric E70 Series Specifications

General

Brand	Mitsubishi Electric
Model	E70 Series
Category	Control Systems
Language	English