Mitsubishi Electric Melsec A Series - Page 192

REPLACEMENT OF THE MELSECNET/10 (REMOTE I/O NETWORK)
5 - 26
5
(3) Parameter of multiplexed remote sub-master station
*1
: Compatible, : Partial change required, × : Incompatible
*1 The multiplexed remote sub-master station is the station type of the multiplex master system.
Only the following CPU modules support the multiplex master system.
• Process CPU
• Redundant CPU
Parameter
name
Description
Compat-
ibility
Precautions for replacementQnA/QnAS series
MELSECNET/10 module
Q series
MELSECNET/H module
Network
parameter
Network type Network type
Starting I/O No. Starting I/O No.
Network No. Network No.
- Total number of (slave) stations
New parameter of MELSECNET/H
(To enable the multiplexed remote
sub-master station to control the
remote I/O station, the setting is
required.)
- Group No.
The group No. is not used in the
remote I/O network.
Set to [0].
- Mode
Set the mode in GX Works2 or GX
Developer network parameters.
-
Network range
assignment
(common
parameter)
Monitoring time
New parameter of MELSECNET/H
(To enable the multiplexed remote
sub-master station to control the
remote I/O station, the setting is
required.)
BW setting
XY setting
Reserved
station
designation
Remote sub-
master station
specification
Supplemental
settings
Refresh parameters Refresh parameters
Routing parameters Routing parameters
Valid module during other
station access
Valid module during other
station access