EasyManua.ls Logo

Mitsubishi Electric MELSEC iQ-R-R04CPU - Chapter 39 Precautions on Programming; 39.1 Instructions Not Available in System Using SIL2 Process CPU; Instructions that Need to be Executed Again in a New Control System

Mitsubishi Electric MELSEC iQ-R-R04CPU
1028 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39 PRECAUTIONS ON PROGRAMMING
39.1 Instructions Not Available in System Using SIL2 Process CPU
685
39
39 PRECAUTIONS ON PROGRAMMING
This chapter describes the precautions on programming for a system using the SIL2 Process CPU.
39.1 Instructions Not Available in System Using SIL2
Process CPU
This section describes the instructions not available in a system using the SIL2 Process CPU.
Instructions that need to be executed again in a new control
system
For an instruction that requires several scans for completing the processing, the instruction will be continuously executed
when the system switching is performed during execution of the instruction. When a completion device has been used in an
execution program of the control system, the completion device will not turn on even though the instruction is completed after
the system switching from the control system to the standby system. However, the completion device will turn on after the
system switching from the control system to the standby system and then to the control system again. Note that the
completion status of the completion device is not reflected to the tracking device. When the system switching is performed
during execution of an instruction, execute the instruction again as required.
For some instructions, an error will occur if an instruction is executed during execution of the same instruction. For the
operation for each instruction that is executed again during execution of the same instruction, refer to the following.
MELSEC iQ-R Programming Manual (CPU Module Instructions, Standard Functions/Function Blocks)
MELSEC iQ-R Programming Manual (Module Dedicated Instructions)
Classification Instruction symbol
Data processing instructions SORTD(_U), DSORTD(_U)
Reading/writing data instructions SP.DEVST, SP.FREAD, SP.FWRITE
Open/close processing instructions SP.SOCOPEN, SP.SOCCLOSE
Socket communications instructions SP.SOCRCV, S.SOCRCVS, SP.SOCSND, SP.SOCCINF, SP.SOCCSET,
SP.SOCRMODE, S(P).SOCRDATA
Module dedicated instructions Instructions that require several scans for completing processing

Table of Contents

Related product manuals