934
APPX
Appendix 10 Parameter List
Appendix 10Parameter List
This section lists parameters.
System parameters
The following is the list of system parameters.
Item Parameter No.
I/O Assignment Base/Power/Extension Cable Setting Slot 0201H
Base, Power Supply Module, Extension Cable 0203H
I/O Assignment Setting Points, Start XY, Module Status Setting 0200H
Control PLC Settings 0202H
Module Name 0203H
Points Occupied by Empty Slot Batch Setting 0100H
Redundant Module Group Setting 0400H
Multiple CPU Setting Communication Setting between
CPUs
CPU Buffer Memory Setting (at refresh END) 0304H
CPU Buffer Memory Setting (at execution of refresh I45) 0308H
PLC Unit Data 0309H
Fixed Scan Communication Function
Fixed Scan Communication Area Setting 0307H
Fixed Scan Communication Setting Fixed Scan Interval Setting of Fixed Scan Communication 0306H
Fixed Scan Communication Function and Inter-module
Synchronization Function
0306H
Operation Mode Setting Stop Setting 0302H
Synchronous Startup Setting 030AH
Other PLC Control Module Setting I/O Setting Outside Group 0305H
Inter-module Synchronization
Setting
Use Inter-module Synchronization Function in System
Select Synchronous Target Unit between Unit 0101H
Fixed Scan Interval Setting of Inter-module Synchronization 0101H
Inter-module Synchronous Master Setting 0102H
To Next Page
Loading...
