4 PROGRAMMING
4.1 Program Example of UCMM Message Communications
101
4
4.
Set the RJ71EIP91 as follows.
[Navigation window] Ö [Parameter] Ö [Module Information] Ö Right-click Ö [Add New Module]
5.
Set the items in "Basic Setting" as follows.
[Navigation window] Ö [Parameter] Ö [Module Information] Ö [RJ71EIP91] Ö [Basic Setting]
6.
Write the set parameters to the CPU module. Then reset the CPU module or turn the system off and on.
[Online] Ö [Write to PLC]
In the program example, default values are used for parameters that are not shown above. For the
parameters, refer to the following.
Page 43 PARAMETER SETTINGS
To Next Page
Loading...
