EasyManua.ls Logo

Mitsubishi Electric MELSEC iQ-RJ71EIP91 - Page 132

Mitsubishi Electric MELSEC iQ-RJ71EIP91
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
130
5 TROUBLESHOOTING
5.6 List of Error Codes
132H An error was detected in the memory. Take measures to reduce noise.
Reset the CPU module, and then switch it to RUN mode. If the
error occurs again even after the above action is taken, the
possible cause is a hardware failure of the module on which the
error occurred. Please consult your local Mitsubishi
representative.
133H Communications have been disconnected. Check whether 'EtherNet/IP communication start request' (Y10) is
on.
134H A timeout occurred in the connection with the external device. Check whether the operating status of the external device is
normal.
Check for errors in the line status.
The line may be busy, so retry at a later time.
135H A timeout occurred in the connection with the external device. Check whether the operating status of the external device is
normal.
Check for errors in the line status.
The line may be busy, so retry at a later time.
The external device may not be able to send data at the
specified RPI due to a high communication load, so specify a
larger RPI and connect again.
136H A timeout occurred in the connection with the external device. Check whether the operating status of the external device is
normal.
Check for errors in the line status.
The line may be busy, so retry at a later time.
137H to 138H An error was detected in the memory. Take measures to reduce noise.
Reset the CPU module, and then switch it to RUN mode. If the
error occurs again even after the above action is taken, the
possible cause is a hardware failure of the module. Please
consult your local Mitsubishi representative.
17FH An error was detected in the memory. Take measures to reduce noise.
Reset the CPU module, and then switch it to RUN mode. If the
error occurs again even after the above action is taken, the
possible cause is a hardware failure of the module. Please
consult your local Mitsubishi representative.
180H An error notification has been received from the external
device. (Extended Status: 100H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is
made for this error and the action to take.
Close the connection of the external device and retry.
Retry after the connection of the external device has been
timed out.
181H An error notification has been received from the external
device. (Extended Status: 103H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
182H An error notification has been received from the external
device. (Extended Status: 106H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
183H The external device cannot find the connection to close.
(Extended Status: 107H)
*1
Check the following items, and then restart the EtherNet/IP
communications.
Is the operating status of the external device normal?
Is the line status normal?
184H An error notification has been received from the external
device. (Extended Status: 108H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
185H An error notification has been received from the external
device. (Extended Status: 109H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
186H An error notification has been received from the external
device. (Extended Status: 110H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
187H An error notification has been received from the external
device. (Extended Status: 111H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
188H An error notification has been received from the external
device. (Extended Status: 112H)
*1
Refer to documentation such as the manuals of the external
device to check the conditions under which a notification is made
for this error and the action to take.
Error code Error details and causes Action

Table of Contents

Related product manuals