3 PROGRAMMING
3.2 Communication Example Using the Submaster Function
163
3
8. Set the data link faulty station setting as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GF11-T2] [Application Settings]
[Supplementary Cyclic Settings] [I/O Maintenance Settings] [Data Link Error Station Setting]
9. Set the operation of master station after reconnection as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GF11-T2] [Basic Settings] [Operation of
Master Station after Reconnection]
10. Write the set parameters to the CPU module on the master station.
[Online] [Write to PLC]
In this example, default values were used for parameters that are not shown above. For the parameter setting,
refer to the chapter explaining the parameters in this manual. ( Page 124 PARAMETER SETTINGS)
To Next Page
Loading...
