4 TROUBLESHOOTING
4.5 List of Error Codes
273
4
D621H Parameter error • Write the network parameter to the CPU module
again.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D622H Parameter error (error in the total number of slave
stations)
• Write the network parameter to the CPU module
again.
• Execute again after correcting the total number of
slave stations.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D623H Parameter error (link scan mode error) • Write the network parameter to the CPU module
again.
• Execute again after correcting the link scan mode
setting.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D624H Parameter error (constant link scan time setting error) • Write the network parameter to the CPU module
again.
• Execute again after correcting the constant link
scan time.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D625H Parameter error (station-based block data assurance
setting error)
• Write the network parameter to the CPU module
again.
• Execute again after correcting the station-based
block data assurance setting.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D626H Parameter error (loopback setting error) • Write the network parameter to the CPU module
again.
• Execute again after correcting the loopback function
settings.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D628H Parameter error (station type error) • Write the network parameter to the CPU module
again.
• Execute again after correcting the station type in the
setting data.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D629H Parameter error (station number range error) • Write the network parameter to the CPU module
again.
• Execute again after correcting the station number in
the setting data within 1 to 120.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D62AH Parameter error (data link faulty station setting error) • Write the network parameter to the CPU module
again.
• Execute again after correcting the data link faulty
station setting.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D62BH Parameter error (output setting error during CPU
STOP)
• Write the network parameter to the CPU module
again.
• Execute again after correcting the output settings
during CPU STOP.
• If the error occurs again even after taking the above,
please consult your local Mitsubishi representative.
D630H Parameter setting of a local station by the CCPASET
instruction has failed.
Execute again after setting "Setting Method of Basic/
Application Settings" under "Parameter Setting
Method" in "Required Settings" to "Program".
Error
code
Error details and causes Action Detailed Information
To Next Page
Loading...
