Mitsubishi Electric MELSEC iQ-RJ71GF11-T2 - Page 58

56
1 FUNCTIONS
1.3 IP Packet Transfer Function
■Setting in the Ethernet adapter module 1 (station No.1)
Use the configuration tool to set the IP address.
1. Set the IP address in the Ethernet adapter module 1 (Ethernet part) as follows.
Setting item tree  NZ2GF-ETB  [Parameter]  "Ethernet"
2. The IP address setting is not required for the Ethernet adapter module 1 (CC-Link IE Field Network part).
The network address set in the master station 1 (station No.0) is automatically assigned.
3. Set the CC-Link IE Field Network gateway in the Ethernet adapter module 1 as follows.
Setting item tree  NZ2GF-ETB  [Parameter]  "CC-Link IE Field Network"  [CC-Link IE Field Network Gateway
Setting]