1 FUNCTIONS
1.3 IP Packet Transfer Function
57
1
Set the gateway as follows.
4. Write the set parameters to the Ethernet adapter module 1.
■Setting in the CPU module 1 and master station 1 (station No.0)
1. Set the routing parameters to the CPU module 1 as follows.
[Navigation window] [Parameter] Targ e t mod u le [CPU parameter] [Routing Setting]
Because the network address is different from that of the request destination device, the Ethernet adapter module 2 (Ethernet
part) does not have a network number. Set the communication path to the network No.2.
2. Set the IP address in the master station 1 (station No.0) as follows.
[Navigation window] [Parameter] [Module Information] Ta rge t modu l e [Application Settings] [IP Address]
3. Write the set parameters to the CPU module 1. Then reset the CPU module 1 or power off and on the system.
■Setting in the CPU module 2, local station 1 (station No.2), and master station 2 (station No.0)
1. Set the routing parameters to the CPU module 2 as follows.
[Navigation window] [Parameter] Targ e t mod u le [CPU parameter] [Routing Setting]
2. Set the IP address in the master station 2 (station No.0) as follows.
[Navigation window] [Parameter] [Module Information] Ta rge t modu l e [Application Settings] [IP Address]
3. The IP address setting is not required for the local station 1 (station No.2).
The network address set in the master station 1 (station No.0) is automatically assigned.
4. Write the set parameters to the CPU module 2. Then reset the CPU module 2 or power off and on the system.
Station where the IP packet passes through last
(Network No. , station No. )
To transmit communications to the request destination ,
the IP packet passes through the station
with the network address No. and station No. .
Request source
Request
destination
To Next Page
Loading...
