Mitsubishi Electric Melsec QJ71LP21 - 5 Parameter Settings

5 - 1 5 - 1
MELSEC-Q
5 PARAMETER SETTINGS
5 PARAMETER SETTINGS
To run the MELSECNET/H, the parameters for the network module mounted to the
programmable controller CPU must be set with GX Developer.
Depending on the network configuration, some parameters must be set, some must be
set as required, and some do not.
The following pages provide lists of parameter settings required for each network
configuration.
Construct a single
network system?
Yes
Yes
See parameter list (4)
shown in this chapter.
No
No
Construct a
redundant system?
Yes
Construct multiple
network systems?
Yes
No
Construct multiple
network systems?
Yes
No (Construct a simplified redundant system.)
Construct multiple
network systems?
See parameter list (1)
shown in this chapter.
See parameter list (4)
shown in this chapter.
See parameter list (2)
shown in this chapter.
See parameter list (4)
shown in this chapter.
See parameter list (3)
shown in this chapter.
No
Start parameter settings.
5