Mitsubishi Electric Melsec QJ71LP21 - 1) Data Sending;Receiving (JP;GP.SEND, JP;GP.RECV)

7 - 36 7 - 36
MELSEC-Q
7 APPLICATION FUNCTIONS
7.4.5 (1) Data sending/receiving (JP/GP.SEND, JP/GP.RECV)
Target station
Refer to Section 6.3.
(a) Instruction format
1) JP/GP.SEND
This instruction sends data to a network module in other station.
Applicable device
Setting
data
Applicable device
Internal device
File register
Link direct device
J
\
Intelligent function
module device
U
\G
Index register
Zn
Constant
K, H, $
Others
Bit Word Bit Word
(S1)
(S2)
(D1)
Instruction format
[Network No. specification]
JP.SEND
Jn
Command
(S1) (S2) (D1)
[Execution condition]
[Instruction symbol]
JP.SEND
[Network module start I/O No. specification]
GP.SEND Un
Command
(S1) (S2) (D1)
[Execution condition][Instruction symbol]
GP.SEND
Setting data
Setting data 1 Description Setting side 2 Data type
Jn
Network No. of the host station (1 to 239, 254)
254: The network specified in Valid module during other station access
User
Binary 16 bits
Un
Start I/O number of the host station's network module
(00 to FE
H
: The higher two digits of the 3-digit I/O number)
Character string
(S1) Start device of the host station that stores control data User, system
Device name
(S2) Start device of the host station that stores send data User
(D1)
The host station's device that is turned on for one scan upon completion of the instruction
(D1)+1 also turns on if the instruction execution has failed.
System Bit
1: Local devices and file registers for each program cannot be used as devices in setting data.
2: The setting side is as shown below.
User : It is data the user sets in the sequence program before execution of a link dedicated instruction.
System: The programmable controller CPU stores the execution result of the link dedicated instruction.