Mitsubishi Electric Melsec QJ71LP21 - Setting the Number of Modules (Network Type)

5 - 7 5 - 7
MELSEC-Q
5 PARAMETER SETTINGS
5.1 Setting the Number of Modules (Network Type)
Set the network type and the station type for each module.
Up to four modules can be set for a combination of MELSECNET/H and CC-Link IE
Controller Network.
Note that, however, there are restrictions on the number of modules mounted for one
programmable controller CPU depending on the CPU model used. (Refer to the user's
manual for the CPU module used.)
For the MELSECNET/H network system, select control station, normal station, or
standby station.
(1) Selection type
Select from the following items:
Item Description
MNET/H mode (Control station) Set this item for a control station of the MELSECNET/H mode.
MNET/H mode (Normal station) Set this item for a normal station of the MELSECNET/H mode.
MNET/10 mode (Control station)
1
Set this item for a control station of the MELSECNET/10 mode.
MNET/10 mode (Normal station)
1
Set this item for a normal station of the MELSECNET/10 mode.
MNET/H mode Stand by station
Set this item for a standby station of a simplified redundant
system.
MNET/H EX (Control station)
Set this item for a control station of the MELSECNET/H
Extended mode.
MNET/H EX (Normal station)
Set this item for a normal station of the MELSECNET/H
Extended mode.
1: The QJ71NT11B does not support MESECNE/10 mode.