Mitsubishi Electric Melsec QJ71LP21 - Page 155

5 - 4 5 - 4
MELSEC-Q
5 PARAMETER SETTINGS
(3) List of parameter settings for a simplified redundant system
Parameter setting item
Necessity for setting by station type
Reference section
Control station Normal station Standby station
Network type
(MNET/H mode
(control station),
MNET/H EX
(control station))
(MNET/H mode
(normal station),
MNET/H EX
(normal station))
(MNET/H
standby station)
Section 5.1
Starting I/O No. Section 5.2.1
Network No. Section 5.2.2
Total stations Section 5.2.3
Group No.
Sections 5.2.4 and
7.4.3
Mode Section 5.2.5
Communication speed setting Section 5.2.6
Network range
assignment
(common parameters)
Monitoring time Section 5.4
LB/LW
settings
Send range of each station
(LB/LW)
Section 5.3.1
Send range of each station
(low-speed LB/LW)
Section 7.3
Pairing setting Section 7.10.3
LX/LY settings Section 5.3.2
I/O master station specification Section 5.3.3
Reserved station specification Section 5.3.4
Supplement
ary settings
Constant link scan Section 5.4
Maximum No. of returns to system
stations in 1 scan.
Section 5.4
Multiplex transmission
specification
Section 5.4
Control station shift setting Section 5.4
Block send data assurance per
station
1 Section 5.4
Block receive data assurance per
station
1 Section 5.4
Transient setting Section 5.4
Low-speed cyclic transmission
specification
Section 5.4
Station inherent parameters Section 5.6
Refresh parameters 2 3 2 3 Section 5.7
Interrupt settings Section 7.5.1
Control station return setting Section 5.5
Standby station compatible module Section 5.9
Redundant settings Section 7.10.4
Interlink transmission parameters Section 7.2
Routing parameters Section 7.4.2
Valid module during other station access Section 5.8
1: In the MELSECNET/H Extended mode, the default check mark is displayed.
2: Default value is not set in LX/LY. Set refresh parameters.
3: Default values are preset for LB/LW.
The system may operate even if refresh parameters have not been set.
For the operation and precautions, refer to Section 5.7.2 (3).
: Set at all times (no default setting).
: Set at all times (default setting provided).
: Set as appropriate.
: Setting unnecessary.