5 - 33 5 - 33
MELSEC-Q
5 PARAMETER SETTINGS
(2) Manual setting by direct input
1) Select "Assignment method".
Select "Points/Start" when entering link device points and start
addresses.
Select "Start/End" when entering start and end addresses of link
devices.
2) Configure the settings for the link side and CPU side devices.
Example: When "Start/End" is selected
LB
0
7FF
3FFF
B
300
AFF
1FFF
2048
points
Network module
CPU
For decimal bit devices,
the start address must
be a multiple of 16.
to
to
To Next Page
Loading...
