7 - 25 7 - 25
MELSEC-Q
7 APPLICATION FUNCTIONS
(5) Setting example
The routing parameter setting examples (A, B) are explained using the following
system configuration.
POINT
(1) Since only one network module can be installed with the Basic model QCPU,
Q00UJCPU, Q00UCPU, Q01UCPU and safety CPU, it cannot be used as a
relay station.
(2) For access via a redundant system, the routing parameters of the request
source or relay station(s) must be changed with the RTWRITE instruction if
system switching occurs in the redundant system.
For details, refer to Section 7.10.8.
(a) Setting example A
The routing parameter must be set for request source 10).
8NS3 9NS38NS29MP1
10) Request source 11) Relay station 12) Request destination
No.
Target
network No.
Relay
network No.
Relay
station No.
10) Request source 1 [9] [8] [2]
To Next Page
Loading...
