7 - 160 7 - 160
MELSEC-Q
7 APPLICATION FUNCTIONS
(2) RTWRITE instruction
The following is a sample program for changing the routing parameters for the
requesting station (network No. 2, station No. 3) shown in (1) of this section using
the RTWRITE instruction.
For details of the RTWRITE instruction, refer to the MELSEC-Q/L Programming
Manual (Common Instruction).
Relay network No. 2
Relay station No. 2
Dummy is set.
Destination network No. 1
Relay network No. 2
Relay station No. 1
Dummy is set.
Destination network No. 1
Relaying via network No. 2, station No. 2
Relaying via network No. 2, station No. 1
To Next Page
Loading...
