7 - 121
7 MOTION PROGRAMS FOR POSITIONING CONTROL
7.15 Special M-Code
The arguments of the special M-codes are shown in Table 7.4 below.
Table 7.4 Special M-Code argument list
Axis command
(Note-1)
Radius
command (R)
Central Point
command (I, J)
M-code
(Note-2)
G-code
Feed
(F)
H L N O P Remark
M00
M01
M02
M30
M98
M99
M100
Other
M-codes
: May be specified.
Blank
: Must not be specified.
(Note-1) : The axis commands are X, Y, Z, U, V, W, A, B, CX, CY, CZ, CU, CV, CW, CA, CB, DX, DZ, DU, DV, DW, DA, DB,
EX, EY, EZ, EU, EV, EW, EA and EB.
(Note-2) : M-codes indicate except M00, M01, M02, M30, M98, M99 and M100.
To Next Page
Loading...
