7 - 129
7 MOTION PROGRAMS FOR POSITIONING CONTROL
7.16 Miscellaneous
The settable arguments in the first character are shown in Table 7.5 below.
Table 7.5 Argument List
[ ] Operator
Logical
operator
Assignment
(=)
GOTO G M Remarks
#
IF
GOTO
/
Depends on the data after "/".
G Refer to Section 7.13.
M
Refer to Section 7.15 for M00,
M01, M02, M30, M98, M99
and M100.
Axis
command
Depends on the G-code in the
modal group (01).
Feed
Depends on the G-code in the
modal group (01).
O
N
Regards the line number and
later as the fist character.
( )
Handles data between "(" and
")" as a comment.
IF
ELSE
END
WHILE
DO
: May be specified.
: Must be specified.
Blank
: Must not be specified.
To Next Page
Loading...
