7 - 124
7 MOTION PROGRAMS FOR POSITIONING CONTROL
7.15.3 M02 Program end
Code M02
Function Program end
Program is ended.
Format
2;M0
[Explanation]
Executing this command ends an execution of program.
This command is required at the end of a program.
[Program Example]
The program which ends a program after positioning control.
G90 ; (Absolute value command)
G01 X100. Y200. F100. ; (Positioning)
X200. Y300. ; (Positioning)
G00 X0. Y0. ; (Positioning)
M02 ; (Program end) ..... Also be enabled by M30.
%
REMARK
M02 and M30 have the same function.
To Next Page
Loading...
