11 - 3
11 COMMUNICATIONS VIA NETWORK
11.2 Access Range of The Communications via Network
11.2.1 Network configuration via the MELSECNET/10(H) or the Ethernet
(1) It can access the other CPU via the network from the programming software (GX
Developer, SW6RN-GSV43P, etc.) of the personal computer connected with the
CPU or serial communication module in USB/RS-232.
(2) It can access the other CPU via the network from the programming software in the
personal computer by connecting the personal computer equipped with Ethernet
to MELSECNET/10(H) or Ethernet board to the Ethernet to MELSECNET/10(H) or
Ethernet.
(3) The access range of above (1) and (2) can be accessed to 8 network points by
setting the routing parameter to the control CPU of the network module and the
CPU which connected the personal computer.
To Next Page
Loading...
