Mitsubishi Electric Q26UD(E)HCPU - Page 350

348
2241
[LOAD ERROR]
Reading of batch-save/load target data from the
SD memory card failed.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
Execute auto loading using any other data
because the batch-save/load target data may
be corrupted.
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
2242
[LOAD ERROR]
A system file (SVLDINF.QSL) does not exist in the
load-target folder.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
Specify a folder where a system file
(SVLDINF.QSL) is stored, and execute auto
loading.
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
2243
[LOAD ERROR]
The file password 32 of the load-destination file is
different from that of the load-source file. Or, a file
password 32 is not set to the load-source file while
the load-destination file has a password.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
Set the same file password 32 to the load-
destination file and the load-source file, and
execute auto loading.
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
2244
[LOAD ERROR]
• When the folder number (1 to 99) is set in
SD909 (Auto loading target folder number), a
folder with the corresponding number does not
exist in the SD memory card.
• The folder number out of the setting range
(other than 0 to 99) is set in SD909 (Auto
loading target folder number).
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
• Check that a folder with the number
corresponding to the one set in SD909
exists in the SD memory card, and execute
auto loading.
• Set the number in SD909 within the setting
range, and execute auto loading.
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
2245
[LOAD ERROR]
Loading data to the load-destination drive has
failed.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
The possible cause is a failure of the CPU
module. Execute auto loading to another
CPU module.
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
2246
[LOAD ERROR]
• When the folder number (1 to 99) is set in
SD909 (Auto loading target folder number), an
SD memory card is not inserted.
• When the folder number (1 to 99) is set in
S
D909 (Auto loading target folder number), the
SD memory card access control switch of the
CPU module is not slid down.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
• Insert an SD memory card, and execute
auto loading.
• Slide up the SD memory card access
control switch, and execute auto loading.
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
Error
code
Error and cause Corrective action
LED status,
CPU status
Corresponding
CPU